Troubleshooting
Troubleshooting
Solve common problems with diagrams, circuits, exports, browser behavior, and login.
Diagram does not update#
Check whether your project data has been changed and saved. Then check whether components are assigned to circuits and whether the diagram function must be reopened or refreshed.
If a schematic already exists, supported electrical saves refresh it. Otherwise generate it explicitly. Check the active cabinet, circuit scope and selected Standard/Classic layout. Regeneration replaces generated output; review its pages again.
Component not assigned to a circuit#
Open the component or circuit data and assign the component to the correct circuit. Then review the situatieschema and eendraadschema again.
Export does not work#
Check whether all required data is present and try again. If the problem continues, note the project name, browser, steps to reproduce, and any error message.
In Export PDF, select at least one content type, wait for the preview and inspect Pages and Layout. Situation-layer checkboxes can exclude content even when it is visible in the editor. Use the preview retry action after correcting project data.
Browser problems#
Use a current browser. Refresh the page if the editor does not respond. If the issue continues, signing in again or reopening the project may help.
Account or login#
Check your email address, password, and account confirmation. Use the recovery options on the login page if you no longer know your password.
Check spam/junk folders, then request a new confirmation email. A delivery error is different from an explicitly disabled email service. An expired or invalid link requires a new request. Requesting password recovery does not change the password until you complete the reset. See Account and recovery.
Protection or cable marks are missing#
Reopen the circuit in Cabinet and check its saved protection, placement and In buis values. Use Beveiliging opslaan. The tube circle and wall-placement marks are independent. Secondary differential assignments are managed in Differential Overview, not by changing the breaker type.
Drawing tools do not start#
Open a project and press Escape to leave the current operation before choosing another tool. Check whether the relevant layer is visible. For a rejected wall edit, adjust the preview or cancel rather than leaving an invalid shape. See Keyboard shortcuts.