Electrical installation

Placing electrical symbols

Place sockets, switches, lighting, and other electrical components on your plan.

Symbols on the plan#

Electrical symbols show where components are located on the situatieschema. This can include sockets, switches, lighting points, appliances, and other available consumers.

Place and review#

Place symbols when the floor plan is sufficiently correct. Then check:

  • Is the symbol in the right location?
  • Is it readable at the selected scale?
  • Does the component belong to a circuit?
  • Are properties such as name or technical data completed where needed?

Component properties#

Double-click a linkable electrical symbol to open its electrical properties. Review voltage, wattage, quantity and AC/DC behavior where available. Defaults are starting values for that symbol type, not measurements of the installation.

Use the network-linking dialog to save circuit assignments and switch/lamp branches. Moving a switch near a lamp does not create a control relationship. See Creating circuits.

Position, dimensions and visibility#

Select a supported object to move or rotate it. D opens dimensions and L changes locking where supported; Escape leaves the active operation. The layers panel controls the visible drawing categories. PDF export has its own layer selection, so check both the canvas and export preview.

Repeated/distributed placement and component-specific options are available only for the tools that offer them. Finish or cancel a placement before switching to another tool.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.